T04E Compressor O Ring

Replacement compressor side o ring for T04E housings.  

S200 Rebuild Kit with 360 Degree Thrust

We found the need to develop a 360 degree thrust kit for the S200 product line to be used in extreme performance applications.  This 360 kit will fit all S200 turbos that came from the factory with a 270 degree bearing. Rebuild kit for S200 turbos,...

Garrett Precision AGP Turbine Clamp Plates

This is a set of turbine clamp plates for Garrett based T3 and T4 turbos.  These fit all Garrett T3 T4, GT, GTX Ball Bearing, Precision Turbo, and AGP turbos.  This is a complete set to install a supercore into a turbine housing.  6 bolts...

Borg Warner S300 Compressor Clamp Plates

This is a set of compressor clamp plates and bolts for a Borg Warner S300 and S300 SXE.  This is a complete set of 4 clamps and 8 screws.

S400 Rebuild Kit with 360 Degree Thrust

Rebuild kit for S400 turbos, including all S400sx and S400 SXE turbo with both twin turbine end piston rings and single turbine end piston rings. Included: 2 journal bearings with retaining clips, 360 degree thrust kit with collar / washer, compressor...

S300 Rebuild Kit with 360 Degree Thrust

Rebuild kit for S300 turbos, including all S360, S362, S363, S366 sx turbos, and all S300 SX-E turbos such as the S362, S363, S364.5, S366, S369, and S372 SXE Included: 2 journal bearings with retaining clips, 360 degree thrust kit with collar / washer,...

T3 T4 Rebuild Kit with 360 Degree Thrust

Rebuild kit for Garrett based T3 and T4 turbos, these will fit AGP branded Z2, Z3 and CW turbos with standard shaft and 1/4" shank.  These fit most Garrett 46, 50, 54, 57, and 60 trim turbos including the 60-1. Included: 2 journal bearings with...

T3 T4 Rebuild Kit with Standard Thrust

Rebuild kit for Garrett based T3 and T4 turbos, these will fit AGP branded Z2, Z3 and CW turbos with standard shaft and 1/4" shank.  These fit most Garrett 46, 50, 54, 57, and 60 trim turbos including the 60-1. Included: 2 journal bearings with...

S200 Rebuild Kit with Standard Thrust

Rebuild kit for S200 turbos, these will fit the S251sx, S256sx, S252SXE, and S257SXE along with other S200 turbos.  This will also fit the old S256-RS turbos Included: 2 journal bearings with retaining clips, thrust kit with collar and washers,...

Borg Warner S300 Turbine Clamp Plates

This is a set of turbine clamp plates for Borg Warner S300 and S300 SXE.  This is a complete set to install a supercore into a turbine housing.  4 bolts and two plates included

Borg Warner S200 Turbine Clamp Plates

This is a set of turbine clamp plates for Borg Warner S200 and S200 SXE.  This is a complete set to install a supercore into a turbine housing.  4 bolts and two plates included