AGP Turbo CW Z475 83mm

Turbo has 83/74 turbine wheel directly interchangeable with Borg Warner S475 177101  95 lbs / min approx 950 horsepower Compressor Specs: - S400 Platform Compressor Housing with 5”...

SRT-4 Caliber AGP Oil Accumulator Catch Can

The Caliber SRT-4 being a high horsepower turbocharged car runs a significant amount of piston-to-wall clearance. The cylinder pressure from the forced air creates more heat in turbocharged...

-4 Female to Male Swivel 90 Degree

-4 Female -4 Male 90 Degree Swivel Steel Fitting This fitting is commonly used at the oil inlet of GT Ball Bearing turbos to change the oil feed direction to 90 degrees

1/4" NPT Female Weld Bung Aluminum (4 pack)

1/4" NPT Female Weld Bung Aluminum Pack of 4

1/4" NPT To -4AN Oil Feed Fitting 90 Degree for S200/S300/S400/S500 and T3T4

1/4 NPT to screw into your T4 Bearing Housing or S200/S300/S400/S500 Borg Warner Turbo-4 Male to connect to your oil feed line 90 Degree Steel Fitting This fitting is commonly used when adapting a -4...

1/4" NPT To -4AN Oil Feed Fitting Straight for S200/S300/S400/S500 and T3T4

1/4 NPT to screw into your T3T4 Bearing Housing S200/S300/S400/S500 Borg Warner Turbo-4 Male to connect to your oil feed line Steel Fitting with o ring on the taper for extra sealingThis fitting...

1/8" NPT Female Weld Bung Aluminum (3 pack)

1/8" NPT Female Weld Bung Aluminum 3 pack

1/8" NPT T3 Bearing Housing Oil Feed Fitting 90 Degree with Restrictor

1/8 NPT to screw into your T3 Bearing Housing -4 Male to connect to your oil feed line 90 Degree Steel Fitting .065" Restrictor This fitting is commonly used when adapting a -4 oil feed line to the...

1/8" NPT T3T4 Bearing Housing Oil Feed Fitting 90 Degree

1/8 NPT to screw into your T3 Bearing Housing -4 Male to connect to your oil feed line 90 Degree Steel Fitting This fitting is commonly used when adapting a -4 oil feed line to the oil inlet of a T3...

1/8" NPT T3T4 Bearing Housing Oil Feed Fitting Straight

1/8 NPT to screw into your T3T4 Bearing Housing -4 Male to connect to your oil feed line Steel Fitting with o ring on the taper for extra sealingThis fitting is commonly used when adapting a -4 oil...

2.5" Aluminum U Bend

2.5" 6061 Aluminum OD .072" wall thickness 3" radius 6-8" legs varies between production runs

2nd Gen Cummins T3 Divided Inlet 4.0" HX40 Outlet 14cm for S300

You love the durability, availability, and affordability of the Borg Warner S300sx series of turbos, however those factory John Deere housings make them a little bit more difficult to install and get...