Product Description
The factory (and all other aftermarket) Air Intake Temperature (IAT) sensor is held into the upper intercooler hose with a grommet. These sensors tend to blow out at higher than factory boost levels. The best way to fix this problem, is to purchase one of our temp sensor kits.
The new IAT sensor is designed to be a direct replacement for the factory's PCM to get an accurate reading, without blowing out and causing a big boost leak. The sensor's body utilizes a 1/4-28 thread pattern and screws into the supplied bung. Splice the two wires into your factory harness, and you're good to go.
Included in the kit is a 1/4-28 stainless steel hex nut. The bung will need to be welded or affixed to your existing intercooler pipe. This sensor threads directly into the AGP Upper hard Pipe.
Product Videos
Custom Field
Product Reviews
5 Reviews Hide Reviews Show Reviews
-
Made the engine light go away did it job
Did it's job
-
Screw in sensor
Screwed right in to the hard pipe in place of one that had a cut wire. Fixed p0113 CEL code.
-
AGP temperature sensor
Cleared code
-
Iat sensor review
Pretty damn good sensor it got the job done until I got the new upper hard pipe. Thanks AGP!
-
someone broke the old one
Got it installed and my P0113 code was gone immediately!!!
