We have been selling this fuel return kit since the Neon SRT-4 was released, so chances are you might have one that needs some fresh parts. Here is our complete parts diagram breakdown and you can order each part separately if needed.
A. -6 Line. This goes from the front of the regulator to the G. QD Rail fitting
B. -4 Line. This is used to connect to the bottom of E. Regulator and runs under the car to the L. Return Tube
C. Gauge. The gauge screws into the side of E. Regulator
D. Bracket. The bracket mounts the E. Regulator to the shock tower with it's included screw and nut.
E. Regulator. Aeromotive's genuine 13109 fuel pressure regulator
F. Hose Clamps. Included are 2 hose clamps that hold the L. Return Tube to the filler neck
G. QD Rail. This Quick Disconnect is made from Billet aluminum and has the -6 90 degree fitting installed, attaching to the factory fuel rail and A. -6 Line
H. QD Regulator. This Quick Disconnect is made from Billet aluminum and attaches to the factory fuel line at the firewall and to the back of the E. Regulator.
I. -4 Fitting Bottom Regulator. This fitting screws into the bottom of the Aeromotive E. Regulator and attaches to B. -4 Line
J. O Ring. These o rings are used to seal the factory regulator/filter after you have blocked off the factory regulating portion using the K. Block Off Bushing
K. Block Off Bushing. This is used to block off the factory regulator inside the factory regulator/filter
L. Return Tube. When returning the unused fuel back to the fuel tank, this tube is placed in the filler neck using F. Hose Clamps